Find link

language:

Find link is a tool written by Edward Betts.

searching for Cutting fluid 10 found (43 total)

Wire saw (1,475 words) [view diff] exact match in snippet view article find links to article

cutting fluid, DWC uses only water or some fluid to lubricate, cool the cut, and remove debris. On some materials DWC may not need water or cutting fluid

Electron-beam freeform fabrication (699 words) [view diff] exact match in snippet view article find links to article

with a 6,000-pound block of titanium and use thousands of liters of cutting fluid to reduce it to a 300-pound item, leaving 5,700 pounds of material that

Ultrasonic/sonic driller/corer (912 words) [view diff] exact match in snippet view article find links to article

into very dense material. This is because of the lack of slurry, or cutting fluid, to reach the drill bit in order to keep it clean and effective. Rotational

Race (bearing) (967 words) [view diff] exact match in snippet view article

grinding stages in one long tube of casings that is showered with a cutting fluid. The 'tube' rests on a hardened steel blade with an angled, highly ground

Reamer (2,507 words) [view diff] case mismatch in snippet view article find links to article

Work Material Cutting Fluid Application Aluminum Soluble oil, kerosene, synthetic fluid Flood Brass None, soluble oil Flood Cast Iron Cold air, none Air

Arbor milling (849 words) [view diff] exact match in snippet view article find links to article

steel tooling. Typical Speeds and Feeds Due to high cutting speeds a cutting fluid is required to lubricate and cool the tool and workpiece. The fluids

Ultrasonic machining (1,654 words) [view diff] exact match in snippet view article find links to article

at drilling deep holes in ceramics because the absence of a slurry cutting fluid and the cutting tool is coated in harder diamond abrasives. In addition

Circular saw (2,196 words) [view diff] exact match in snippet view article find links to article

material by both the teeth of the blade as well as the coolant or other cutting fluid used. The rotary motion of a circular saw lends itself to cutting hard

White spirit (1,607 words) [view diff] exact match in snippet view article find links to article

thread cutting and reaming lubricant. White spirit is commonly used for cutting fluid in ultraprecision lathes (commonly referred to as diamond turning machines)

Nanofluid (3,893 words) [view diff] case mismatch in snippet view article find links to article

Vasu, V.; Kumar, K. Manoj (2011-12-01). "Analysis of Nanofluids as Cutting Fluid in Grinding EN-31 Steel". Nano-Micro Letters. 3 (4): 209–214. doi:10